Rent Low Frequency Amplifier | Maxim Instruments Corporation

Featured Products

Low Frequency Amplifier

Low Frequency Amplifiers are used for low power amplification at low microwave frequencies. They typically amplify across a narrow spectrum of frequencies.

AE Techron 7224 Audio Bandwidth Power Amplifier DC – 300 kHz 1100W

The AE Techron 7224 is a 4-quadrant power amplifier that offers the features of larger industrial amplifiers in a smaller 2U size that runs from single phase 120/230VAC. It features DC - 300 kHz bandwidth, controlled-current or controlled-voltage mod... View Details >>

AE Techron 7548 DC-enabled High Power Amplifier DC – 100 kHz 12kW

The AE Techron 7548 amplifier is a DC-enabled, high-powered unit designed to provide very low noise and fast slew rates. A single 7548 has an output capability of 100 amperes peak and 200 volts peak when driving typical MRI gradient coil loads. It c... View Details >>

AE Techron 7782 Power Amplifier DC – 50 kHz 3.3kW

The AE Techron 7782 is a 3.3 kW power amplifier that has a DC to 50 kHz small signal band-width, 150Vpk, and up to 150Apk power. The 7782 is the original member of the 7000 series, offered now as a remanufactured product; it offers a balance of great... View Details >>

AE Techron 7782HC Power Amplifier DC – 50 kHz 3.3kW

AE Techron 7782HF Power Amplifier DC – 200 kHz 4kW DO-160 Testing

The AE Techron 7782HF amplifier is a DC-enabled, extended frequency unit best suited for controlled voltage applications that require voltages between 50 kHz to 100 kHz. At frequencies below 20 kHz, the 7782HF can provide 40mSec bursts of 180 amps pe... View Details >>

AE Techron 7782HF/HC Power Amplifier DC – 200 kHz 4kW DO-160 Testing

The AE Techron 7782HF/HC amplifier is a DC-enabled unit optimized for high-power, continuous operation into very-low-impedance loads. A single 7782HF/HC can output a 40 mSec pulse with up to 150 amperes peak current. If more current is needed, up to ... View Details >>

AE Techron 7796 Power Amplifier DC – 200 kHz 22kW MIL-STD 704

The AE Techron 7796 amplifier is a high-powered, DC-enabled unit designed to provide clean, reliable power for gradient coils in magnetic resonance imaging systems or in applications that require both significant short-term (burst) and long-term (con... View Details >>

AE Techron 7796HC Power Amplifier DC – 200 kHz 22kW MIL-STD 704

AE Techron 8101 Power Supply Amplifier Dual Channel AC Coupled

The AE Techron 8101 power supply amplifier features an advanced switch-mode design that results in low noise and distortion, and high power density. It is configured as a dual-channel, AC-coupled, controlled voltage amplifier ideal for reactive loads... View Details >>

AE Techron 8102 Power Supply Amplifier Single Channel DC Coupled

The AE Techron 8102 power supply amplifier features an advanced switch-mode design that results in low noise and distortion, and high power density. It is configured as a single-channel, DC-coupled, controlled voltage amplifier ideal for reactive lo... View Details >>

Agilent 8347A RF Amplifier 100 kHz - 3 GHz

The 8347A is a general-purpose broadband instrumentation amplifier capable of providing gain and power to overcome systematic RF losses, drive high-power devices and improve measurement system performance. The 8347A can be used to increase low-level ... View Details >>

Amplifier Research 10000A225 RF Amplifier 10 kHz – 225 MHz 10000W

Amplifier Research 10000A225 is a self-contained, broadband, completely solid state amplifier designed for applications where instantaneous bandwidth and high gain are required. Thee amplifier is liquid-cooled for high performance and reliability (ma... View Details >>

Amplifier Research 1000A225 RF Amplifier 10 kHz – 225 MHz 1000W

Amplifier Research 1000A225 is a self-contained, air-cooled, broadband, completely solid-state amplifier designed for applications where instantaneous bandwidth and high gain are required. Push-pull MOSFET circuitry is utilized in all high power stag... View Details >>

Amplifier Research 1000W1000D RF Amplifier 80 MHz – 1000 MHz 1000W

Amplifier Research 1000W1000D is a self-contained, air-cooled, broadband, completely solid-state amplifier designed for applications where instantaneous bandwidth and high gain are required. Push-pull circuitry is utilized in all high power stages in... View Details >>

Amplifier Research 1000W1000E RF Amplifier 80 MHz – 1000 MHz 1000W

Amplifier Research 1000W1000E is a self-contained, air-cooled, broadband, completely solid-state amplifier designed for applications where instantaneous bandwidth and high gain are required. Push-pull circuitry is utilized in all high power stages in... View Details >>

Amplifier Research 100A250A RF Amplifier 10 kHz – 250 MHz 100W

Amplifier Research 100A250A amplifier is a self-contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortio... View Details >>

Amplifier Research 100A400 RF Amplifier 100 kHz – 400 MHz 100W

Amplifier Research 100A400 amplifier is a self-contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion... View Details >>

Amplifier Research 100L RF Amplifier

The Amplifier Research 100L RF Power Amplifier delivers up to 100 Watts of CW Power into 50 Ohms from 10 kHz to 220 MHz.... View Details >>

Amplifier Research 100L-M9 RF Amplifier

The Amplifier Research 100L RF Power Amplifier delivers up to 200 Watts of CW Power into 50 Ohms from 1 MHz to 200 MHz.... View Details >>

Amplifier Research 100W1000B RF Amplifier 1 MHz – 1000 MHz 100W

Amplifier Research 100W1000B is a portable, self-contained, air-cooled, broadband, completely solid-state amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. Push-pull circuitry is utilized in all ... View Details >>

Amplifier Research 10W1000C RF Amplifier 500 kHz - 1000 MHz 10W

Amplifier Research 10W1000C is a portable, self-contained, air-cooled, broadband, solid state amplifier designed for applications where instantaneous bandwidth and high gain are required. Push-pull circuitry is utilized in the high power stages to lo... View Details >>

Amplifier Research 10WD1000 RF Amplifier DC – 1000 MHz 10W

Amplifier Research 10WD1000 is a portable, self-contained, air-cooled, broadband, solid state amplifier designed for applications where extensive bandwidth and high gain are required. Push-pull circuitry is utilized in all of the high power stages in... View Details >>

Amplifier Research 1500A3 RF Amplifier 10 kHz – 3 MHz 1500W

Amplifier Research 1500A3 is a self-contained, air-cooled, broadband, solid-state amplifier designed for applications where instantaneous bandwidth and high gain are required. The Model 1500A3, when used with an RF sweep generator, will provide a... View Details >>

Amplifier Research 1500W1000 RF Amplifier 80 MHz – 1000 MHz 1500W

Amplifier Research 1500W1000 is a self-contained, air -cooled, broadband, completely solid-state amplifier designed for applications where instantaneous bandwidth and high gain are required. Push-pull circuitry is utilized in all high power stages in... View Details >>

Amplifier Research 150A100B RF Amplifier 10 kHz – 100 MHz 150W

Amplifier Research 150A100B amplifier is a self-contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortio... View Details >>

Amplifier Research 150A250 RF Amplifier 100 kHz – 250 MHz 150W

Amplifier Research 150A250 amplifier is a self-contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion... View Details >>

Amplifier Research 150A400 RF Amplifier 100 kHz – 400 MHz 150W

Amplifier Research 150A400 amplifier is a self-contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion... View Details >>

Amplifier Research 150W1000 RF Amplifier 80 MHz – 1000 MHz 150W

Amplifier Research 150W1000 is a portable, self-contained, air-cooled, broadband, completely solid-state amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. Push-pull circuitry is utilized in all h... View Details >>

Amplifier Research 16000A225 RF Amplifier 10 kHz – 225 MHz 16000W

The Model 16000A225 is a self-contained, broadband, completely solid-state amplifier designed for applications where instantaneous bandwidth and high gain are required. The amplifier is air cooled using internal self-contained liquid cooling for high... View Details >>

Amplifier Research 1S1G4A Solid State Broadband Amplifier

The Model 1S1G4A is a solid state, self-contained, air-cooled, broadband amplifier designed for applications where instantaneous bandwidth and high gain are required. Housed in a stylish contemporary cabinet, the unit is designed for benchtop use, bu... View Details >>

« previous12 3 4 5 6 7 next »

Standards

CISPR

CISPR 11

CISPR 14 - 1

CISPR 14 - 2

CISPR 16 - 1

CISPR 16 - 2

CISPR 16 - 3

CISPR 16 - 4

CISPR 22

CISPR 24

IEC

IEC/TR EN 61000 - 1 - 1

IEC/TR EN 61000 - 2 - 1

IEC/TR EN 61000 - 2 - 3

IEC EN 61000 - 3 - 2

IEC EN 61000 - 3 - 4

IEC/TC EN 61000 - 3 - 5

IEC EN 61000 - 4 - 2

IEC EN 61000 - 4 - 3

IEC EN 61000 - 4 - 4

IEC EN 61000 - 4 - 5

IEC EN 61000 - 4 - 6

IEC EN 61000 - 4 - 7

IEC EN 61000 - 4 - 8

IEC EN 61000 - 4 - 9

IEC EN 61000 - 4 - 11

European

EN 50 081 part 1

EN 50 081 part 2

EN 55 011

EN 55 013

EN 55 014

EN 55 015

EN 55 020

EN 55 022

EN 55 024

EN 50 082 part 1

EN 50 082 part 2

EN 50 093

American

FCC Part 15

MIL-STD - 461E