Automotive
|
|
|
| EM TEST AUTOWAVE Automotive Waveform Generator | Battery simulation becomes more and more an issue in today´s automotive testing. Waveforms are getting more and more complex. Standardized single phenomena like cranking are still tested but real-life signals are of even higher interest for tes... View Details >>
|
|
|
|
| EM TEST CWS 500N1 Continuous Wave Simulator 80W | The CWS 500N1 is the most compact single box test equipment for testing conducted rf immunity as per IEC 61000-4-6 and related standards with a frequency range of 100kHz to 300MHz. Apart from the 1kHz 80% AM signal the CWS 500N1 also generates a 2 Hz... View Details >>
|
|
|
|
| EM TEST PFS 200N Automotive Fail Simulator | The PFS 200N Automotive Power Fail simulator is used to comply with standard requirements, mainly from vehicle manufacturers, to perform fast voltage dips ad drops (micro-interruptions). Some standards specify very fast rise and fall times below 1 mi... View Details >>
|
|
|
|
|
|
|
|
|
|
| TESEQ PA 5740 Power Amplifier/Battery Simulator | This battery simulator is designed to replace the vehicle battery in the test environment. These sources must fulfill various criteria concerning power rating, voltage, slew rate, impedance, etc. depending on the particular application. Bipolar curre... View Details >>
|
|
|
| TESEQ PA 5840 Power Amplifier/Battery Simulator | This battery simulator is designed to replace the vehicle battery in the test environment. These sources must fulfill various criteria concerning power rating, voltage, slew rate, impedance, etc. depending on the particular application. Bi-polar curr... View Details >>
|
|
|