Products
- Amplifier
- Analyzer
- Antenna
- Automotive EMC
- Cable Fault Locator
- Calibrator
- Chamber / Oven
- Coupling / Decoupling (CDN)
- Curve Tracer
- Data Acquisition
- Electronic Load
- EMC / EMI
- Environmental
- ESD Simulator
- Generator
- GTEM / TEM Cell
- Harmonics & Flicker
- Hipot
- LISN
- Mains Dips & Drops
- Meter
- Oscilloscope
- PIM Test Solution
- Power Supply
- RF Field Monitor System
- Thermostream
Featured Products
California Instruments MX135-3 High Output AC Power Source 135kVA
IFI T4026-50 High Power TWT Amplifier 26.5 GHz – 40 GHz 50W
IFI T2618-50 High Power TWT Amplifier 18 GHz – 26.5 GHz 50W
IFI TCCX2500 Tetrode Tube RF Amplifier 10 kHz – 220 MHz 2500W
California Instruments MX45-3 High Output AC Power Source 45kVA
IFI M406 Tetrode Tube RF Amplifier 10 kHz – 220 MHz 1000W
Preamplifier
A preamplifier (preamp) is an electronic amplifier that prepares a small electrical signal for further amplification or processing. A preamplifier is often placed close to the sensor to reduce the effects of noise and interference. It is used to boost the signal strength to drive the cable to the main instrument without significantly degrading the signal-to-noise ratio (SNR).
Standards
| CISPR |
| CISPR 11 |
| CISPR 14 - 1 |
| CISPR 14 - 2 |
| CISPR 14 - 2 |
| CISPR 16 - 1 |
| CISPR 16 - 2 |
| CISPR 16 - 3 |
| CISPR 16 - 4 |
| CISPR 22 |
| CISPR 24 |
| IEC |
| IEC/TR EN 61000 - 1 - 1 |
| IEC/TR EN 61000 - 2 - 1 |
| IEC/TR EN 61000 - 2 - 3 |
| IEC EN 61000 - 3 - 2 |
| IEC EN 61000 - 3 - 4 |
| IEC/TC EN 61000 - 3 - 5 |
| IEC EN 61000 - 4 - 2 |
| IEC EN 61000 - 4 - 3 |
| IEC EN 61000 - 4 - 4 |
| IEC EN 61000 - 4 - 5 |
| IEC EN 61000 - 4 - 6 |
| IEC EN 61000 - 4 - 7 |
| IEC EN 61000 - 4 - 8 |
| IEC EN 61000 - 4 - 9 |
| IEC EN 61000 - 4 - 11 |
| European |
| EN 50 081 part 1 |
| EN 50 081 part 2 |
| EN 55 011 |
| EN 55 013 |
| EN 55 014 |
| EN 55 015 |
| EN 55 020 |
| EN 55 022 |
| EN 55 024 |
| EN 50 082 part 1 |
| EN 50 082 part 2 |
| EN 50 093 |
| American |
| FCC Part 15 |
| MIL-STD - 461E |