|
Display Type
|
Transflective LCD, monochrome
|
|
Display Size
|
10 cm (4 inch), resolution 240 x 320 dots
|
|
Backlight
|
White LEDs, selectable illumination time (OFF, 5s, 10s, 30s, 60s, PERMANENT)
|
|
Refresh Rate
|
200 ms for bar graph and graphics, 400 ms for numerical results
|
|
MEASUREMENT FUNCTIONS
|
|
Result Units
|
mW/cm2, W/m2, V/m, A/m, % of Standard
|
|
Display Range, Fixed Triads
|
0.0001 to 9999 for all units (4 digits)
|
|
Display Range, Variable Triads
|
0.01 V/m to 100 kV/m0.027 mA/m to 265.3 A/m0.265 μW/m2 to 26.53 MW/m2 0.027 nW/cm2 to 2.653 kW/cm2 0.0001% to 9999%
|
|
Result Types (Isotropic, RSS)
|
Actual (ACT), Maximum (MAX), Minimum( MIN), Average (AVG), Maximum Average (MAX AVG)
|
|
Result Types (X-Y-Z mode)
|
Actual X, Actual Y, Actual Z (requires a probe with separate axes)
|
|
Averaging Time
|
Selectable, 4 seconds to 30 minutes (2 second steps)
|
|
Spatial Averaging
|
Discrete or continuously
|
|
Multi-position Spatial Averaging
|
Averaging of up to 24 spatially averaged results, each position and total will be stored
|
|
History View
|
Graphical display of actual results versus time (span of 2 minutes to 8 hours)
|
|
Frequency Correction
|
1 kHz to 100 GHz or OFF (direct frequency entry, interpolation between calibration points)
|
|
Hot Spot Search
|
Audible indicator for increasing and decreasing field strength (result type Act or Max)
|
|
Alarm Function
|
2 kHz audible signal (4 Hz repetition), adjustable threshold
|
|
Timer Logging
|
Start time pre-selection: up to 24 hours or immediatelyLogging duration: up to 100 hoursLogging interval: 1 second to 6 minutes (in 11 steps)
|
|
RESULTS MEMORY
|
|
Physical Memory
|
12 MB non-volatile flash memory for measurement results and voice comments
|
|
Storing Capacity
|
Up to 5000 results (including test parameters, time stamp and GPS data when available)
|
|
INTERFACES
|
|
Remote Control
|
Via USB or optical RS-232 interface (selectable)
|
|
USB
|
Serial, full duplex, 460 kBaud (virtual COM port), multi-pin connector
|
|
Optical Interface
|
Serial, full duplex, 115 kBaud, no parity, 1 start and 1 stop bit
|
|
Earphone
|
3.5 mm TRS, > 16 ohms (mono), for voice recorder option only
|
|
External Trigger (to store results)
|
Uses the multi-pin connector. Interface cable with BNC connector available as an option, triggers when contacts shorted.
|
|
External GPS Receiver
|
Uses the multi-pin connector. GPS receiver with interface cable is available as an option
|
|
Probe Interface
|
Plug-and-play auto detection, compatible with all NBM series probes
|
» 
