Antenna

An antenna is an electrical device which converts electric power into radio waves, and vice versa. It is usually used with a radio transmitter or radio receiver. In transmission, a radio transmitter supplies an oscillating radio frequency electric current to the antenna's terminals, and the antenna radiates the energy from the current as electromagnetic waves (radio waves). In reception, an antenna intercepts some of the power of an electromagnetic wave in order to produce a tiny voltage at its terminals, which is applied to a receiver to be amplified.

• Active Loop Antenna
• Antenna Kit
• Biconical Antenna
• Bilogical Antenna
• Combilog Antenna
• Conical Antenna
• Dipole Antenna
• Double Ridged Antenna
• Horn Antenna
• Log Periodic Antenna
• Loop Antenna
• Monopole Antenna
• Tripod

Filter: 

[show all brands] A.H. SystemsAmplifier ResearchCom-PowerElectro MetricsEmcoETS-LindgrenSolar ElectronicsTESEQ

ETS-Lindgren 3186 Dual Stacked LPDA Antenna 1 GHz – 18 GHz ETS-LINDGREN’S MODEL 3186 is dual stacked log periodic dipole array antennas (LPDA), each of the two separate LPDAs comprising the dual array are 100 Ω antennas. When assembled in parallel, the results are a 50 Ω input impedance a... View Details >>

ETS-Lindgren 3301C Active Monopole Antenna 30 Hz – 50 MHz The Model 3301C Active Monopole Antenna is designed to provide reception of an electric field throughout its frequency range, in a single band, without tuning or band switching. The 3301C Active Monopole Antenna factor 3 dB roll-off points are at ... View Details >>

ETS-Lindgren 3303 Passive Broadband Monopole Antenna 1 kHz – 30 MHz The Model 3303 is a passive broadband electric field monopole transmitting antenna that has a frequency range of 1 kHz to 30 MHz. It features manual band switching between 0.001 - 5 MHz and 5 - 30 MHz. The maximum power handled Model 3303 is 1 kW.... View Details >>

ETS-Lindgren 6507 Active Shielded Loop Antenna 1 kHz – 30 MHz The preamplifier helps this loop antenna produce good sensitivity and almost constant antenna factors. The saturation indicator is activated when an incoming signal exceeds the 5 V/m saturation limit of the internal preamplifier. Power for the preamp... View Details >>

ETS-Lindgren 6509 Passive Loop Antenna 1 kHz – 30 MHz The base of the Model 6509 loop antenna contains a type N female connector and a manually switchable four-band transformer. The transformer gives the antenna greater efficiency resulting in a better conversion of power to field strength. Every loo... View Details >>

ETS-Lindgren 6511 Shielded Loop Antenna 20 Hz – 5 MHz The Model 6511 is designed for both Emissions and Immunity tests. Every loop antenna can be individually calibrated in accordance with the IEEE-291 Section 2.3.1 methods, using NIST traceable equipment. By knowing the actual antenna factors and perfo... View Details >>

ETS-Lindgren 6512 Shielded Loop Antenna 10 kHz - 30 MHz The Model 6512 is a passive loop antenna designed for both emissions and immunity tests. Every loop antenna can be individually calibrated in accordance with the IEEE-291 Section 2.3.1 methods, using NIST traceable equipment. By knowing the actual... View Details >>

ETS-Lindgren 7603 Coil Antenna 20 Hz - 50 kHz The Model 7603 is built from the specifications in the original MIL-STD-461 document. The Model 7603 is a magnetic field generating coil 12.0 cm (4.75 in) diameter, made of delrin and wound with 10 turns of AWG-16 wire. Every loop antenna can be ... View Details >>

ETS-Lindgren 7604 Shielded Coil Antenna 20 Hz - 500 kHz The Model 7604 is a magnetic field pick-up coil 13.3 cm (5.25 in) diameter, and has a loop that is constructed of aluminum. The loop has 36 turns of 7 x 41 Litz wire for lower inductance. Every loop antenna can be individually calibrated in accord... View Details >>

ETS-Lindgren 7605-7606 Coil Antenna/Shielded Coil 30 Hz - 100 kHz The Model 7605, a radiating loop, and the Model 7606, a sensing loop, are used as part of a system to verify the ability of an EUT to withstand radiating magnetic fields. The Model 7605 is a 20-turn coil of AWG-12 enamel-insulated copper wire and fea... View Details >>

Solar 7334-1 Loop Antenna For RE01 and RE101 Magnetic Emissions Tests. The Solar Type 7334-1 Loop Antenna has been designed as a substitute for the AT-205/URM-6 antenna and is a replacement for Eaton Model 94607-1. It uses 36 turns of wire on a 5.25" (13.3 cm) diamete... View Details >>

Solar 7429-1 Loop Antenna For RS01 Magnetic Field Tests. The loop antenna used for generating radiated magnetic fields is fully described in Figure 1A of MIL-STD-461A. It consists of ten urns of number 16 A.W.G. wire on an insulated from 4.72" (12 cm) in diameter. The... View Details >>

Solar 9130-1 Loop Antenna For Receiving or Generating Magnetic Fields 10 kHz – 3 MHz This antenna was designed as a replacement for Eaton 94608-1. It is similar to Stoddart 91117-2, 30-inch diameter loop, supplied with AN/URM-6B and NM-10A EMI receivers. In addition to o... View Details >>

Solar 9230-1 Radiating Loop TYPE 9229-1 Loop Sensor For MIL-STD-461D/RS101 Magnetic Field Tests. Test Method RS101 of MIL-STD-461D requires radiated magnetic fields over the frequency range 30 Hz to 100 KHz to determine the susceptibility or immunity of the equipment under test (EUT). Two loop ant... View Details >>

TESEQ BHA 9118 Broadband Horn Antenna 1 GHz – 18 GHz The BHA 9118 is a linearly polarized broadband antenna which is ideal for many applications particularly EMC/RF measurements. It can be used for both receiving and transmitting. A precision ‘N’ connector is used to provide low VSWR and high power... View Details >>

TESEQ BHA 9220 Broadband Horn Antenna 0.2 GHz – 2 GHz The BHA 9220 is a linearly polarized broadband antenna which is ideal for many applications particularly EMC/RF measurements. It can be used for both receiving and transmitting. A precision ‘N’ connector is used to provide low VSWR and high power... View Details >>

TESEQ CBL 6111D BILOG Antenna 30 MHz – 1 GHz The CBL 6111 is a high performance ultra wideband BiLog® antenna designed for emission and immunity EMC testing. This is the original ‘classic’ BiLog® combining two antennas in one, making savings of at least 20 - 30% on test time and red... View Details >>

TESEQ CBL 6112D BILOG Antenna 30 MHz – 2 GHz The CBL 6112D operates over the unprecedented, wide range 30 MHz to 2 GHz. It effectively combines the performance of three standard EMC antennas, the Biconical, the Log Periodic and the Waveguide Horn. Considerable savings in the order of 40 - 50% c... View Details >>

TESEQ CBL 6141B COMPACT X-WING BILOG Antenna 30 MHz – 2 GHz For RF EMC emission and immunity testing in compact anechoic chambers. The combination of BiLog® technology with novel low frequency, folded elements (X-Wing®) allows low frequency power to be efficiently projected forward at 80 MHz without s... View Details >>

TESEQ CBL 6143A COMPACT X-WING BILOG Antenna 30 MHz – 3 GHz The combination of BiLog® technology with novel low frequency, folded elements (X-Wings®) allows low frequency power to be efficiently projected forward without significantly affecting the high frequency performance and, at the same time, red... View Details >>

TESEQ CBL 6144 X-WING BILOG Antenna 26 MHz – 3 GHz The combination of BiLog® technology with novel low frequency, folded elements (X-Wings®) allows low frequency power to be efficiently projected forward without significantly affecting the high frequency elements. The CBL 6144 gives an incred... View Details >>

TESEQ DPA 3000 Biconical Dipole Antenna 800 MHz – 2.8 GHz The dipole antenna DPA 3000 operates as a field strength measuring antenna in the frequency range 800 to 2800 (3000*) MHz. The DPA 3000 is constructed so that it can be converted easily to a Reference Radiation Source in combination with the Referenc... View Details >>

TESEQ DPA 4000A COMPACT Biconical Antenna 200 MHz – 1000 MHz The dipole antenna DPA 4000 operates as a field strength measuring antenna in the frequency range 200 (30*) to 1000 MHz. The DPA 4000 is constructed so that it can be converted easily to a Reference Radiation Source in combination with the Reference ... View Details >>

TESEQ HLA 6120 Loop Antenna 9 kHz – 30 MHz The HLA 6120 is ideal for the 3 m magnetic field measurements as required e.g. by CISPR 11 (reference CISPR 16-1-4 and CISPR 16-2-3) and FCC 18. The built-in preamplifier matches the extremely low impedance of the loop to the measuring receiver. The ... View Details >>

TESEQ UPA 6108 Log Periodic Antenna 300 MHz – 1 GHz The UPA 6108 and UPA 6109, suitable for CISPR/IEC/EN, FCC, MIL-STD testing, are small yet rugged antennas covering the frequency range 200 MHz - 1 GHz (UPA 6109), and 300 MHz - 1 GHz (UPA 6108). Manufactured from aluminum and acetyl-copolymer, these ... View Details >>

TESEQ UPA 6109 Log Periodic Antenna 200 MHz – 1 GHz The UPA 6108 and UPA 6109, suitable for CISPR/IEC/EN, FCC, MIL-STD testing, are small yet rugged antennas covering the frequency range 200 MHz - 1 GHz (UPA 6109), and 300 MHz - 1 GHz (UPA 6108). Manufactured from aluminum and acetyl-copolymer, these ... View Details >>

TESEQ UPA 6192 Pre-compliance Antenna 30 MHz – 2 GHz The UPA 6192 antenna is hybrid antenna with the characteristics similar to a broad band dipole in the range 30 - 200 MHz and a log periodic antenna in the range 200-2000 MHz. The adaptor mount also assists in easy rotation of the polarization between... View Details >>

TESEQ VBA 6106 Biconical Antenna 30 MHz – 300 MHz The lightweight antenna VBA 6106A offers a compact solution to measurements in the frequency range 30 to 300 MHz. It is ideal for open site measurements or applications in anechoic chambers where space is at a premium. The VBA 6106A has a coaxial wou... View Details >>