»  Categories   »      Loop Antenna   »    EMC / EMI   »    Active Loop Antenna   »    Antenna  

image enlarge

Com-Power AL-130 Active Loop Antenna 9 kHz – 30 MHz

Description

The AL-130 is a broadband active receiving loop an¬tenna for electromagnetic field measurements from 9 kHz - 30 MHz This antenna uses a 19 inch shielded loop for magnetic field (H-Field) measurements.

The AL-130 has built in active electronics that pro¬vide impedance matching, linear antenna factors and higher antenna sensitivity, the output impedance is matched to 50 Ohms, so that it can be directly connected to any spectrum analyzer without an additional matching network.

The front panel has indicators for antenna saturation and battery status. The internal NimH batteries take about two hours to fully charge and can operate the antenna for 8 hours continuously. A charger is included with each antenna.

Features

  • Wide Frequency Range - 9 kHz to 30 MHz
  • Battery Powered
  • Built in Preamplifier
  • Saturation Indicator

Com-Power AL-130 Application

 The loop antenna is utilized for testing to meet the various EMC requirements specified by FCC, CISPR, MIL-STD and EN. This antenna is specified for open field emissions testing below 30 MHz It is as­sumed that in the far field the ratio of E and H field will remain the same as the characteristic impedance of the medium.

The loop antenna is positioned with its plane vertical at the specified distance from the EUT. In addition to the EUT rotation, the loop antenna also has to be rotated about its vertical and horizontal axis to maxi­mize emissions. This procedure is described in detail in ANSI C63.4.

Monopole antennas (such as the AM-741) also op­erate in the same frequency range as a loop antenna, but are used for E-field measurements and require a counter poise.

Specifications

Frequency range

9 kHz - 30 MHz

Dynamic range

110 dB at 1 MHz

Sensitivity

10 dBμV/m at 1 MHz

1 dB compression point

3 V/m

Output Impedance

50 Ohm

Connector type

BNC

Power

6V, NimH battery pack

Charger output

6 VDC, 500 mA

Weight

6 lbs / 2.7 kgs

Loop diameter

19 inches / 49 cm

Amplifier section

10.25 x7.25 x 2.5 inches. / 26 x 18.4 x 6.4 cm

Standards

CISPR
CISPR 11
CISPR 14 - 1
CISPR 14 - 2
CISPR 14 - 2
CISPR 16 - 1
CISPR 16 - 2
CISPR 16 - 3
CISPR 16 - 4
CISPR 22
CISPR 24
IEC
IEC/TR EN 61000 - 1 - 1
IEC/TR EN 61000 - 2 - 1
IEC/TR EN 61000 - 2 - 3
IEC EN 61000 - 3 - 2
IEC EN 61000 - 3 - 4
IEC/TC EN 61000 - 3 - 5
IEC EN 61000 - 4 - 2
IEC EN 61000 - 4 - 3
IEC EN 61000 - 4 - 4
IEC EN 61000 - 4 - 5
IEC EN 61000 - 4 - 6
IEC EN 61000 - 4 - 7
IEC EN 61000 - 4 - 8
IEC EN 61000 - 4 - 9
IEC EN 61000 - 4 - 11
European
EN 50 081 part 1
EN 50 081 part 2
EN 55 011
EN 55 013
EN 55 014
EN 55 015
EN 55 020
EN 55 022
EN 55 024
EN 50 082 part 1
EN 50 082 part 2
EN 50 093
American
FCC Part 15
MIL-STD - 461E