EMC / EMI
Electromagnetic compatibility (EMC) is the branch of electrical sciences which studies the unintentional generation, propagation and reception of electromagnetic energy with reference to the unwanted effects (Electromagnetic interference, or EMI) that such energy may induce. EMC aims to ensure that equipment items or systems will not interfere with or prevent each other's correct operation through spurious emission and absorption of EMI. EMC is sometimes referred to as EMI Control, and in practice EMC and EMI are frequently referred to as a combined term "EMC/EMI".
|
|
|
| | Haefely PIM 120 & PCD 120 10/700us Test System | To test telecom systems the 10/700us impulse also called telecom impulse is used. This impulse is characterized by high energy and a relative fast rise time.
The 10/700us test system includes with the impulse module PIM 120 and the automatic coupl... View Details >>
|
|
|
|
|
|
|
|
| | Haefely PSURGE 8000 Surge Platform Test System | This system meets ALL your current and future Surge Testing requirements! A modular expandable system that grows with your application needs.
The modular concept is built around a PC based host controller (the PSURGE 8000 Controller) with physica... View Details >>
|
|
|
|
|
|
|
|
|
|
|
|
| | Solar 2352-1 Audio Power Amplifier 200 Watt | For Conducted Audio Frequency Susceptibility Testing.
The Solar Model 2352-1 Audio Power Amplifier has a wide band frequency response and is capable of providing up to 200 watts at 1000 Hz into 2.0 ohms. Requires approximately 0.5 volts signal inp... View Details >>
|
|
|
|
| | Solar 2854-1 Transient Generator | For MIL-STD-461F CS106 Conducted Transient Susceptibility Test.
The generator provides 5 μS ±22 %, pulse with a 1.5 μS ± 0.5 μS rise time across a 5.0 ohm non-inductive resistor. Voltage is adjustable to g... View Details >>
|
|
|
|
| | Solar 6220-1A Audio Isolation Transformer | The Solar 6220-1A Audio Isolation Transformer was especially designed for screen room use in making conducted audio frequency susceptibility tests as required by MIL-STD-461/462 and other EMI specifications.
The transformer may also be used as a p... View Details >>
|
|
|
|
| | Solar 6550-1 Power Sweep Generator | 100 Watt Source For Conducted Audio Frequency Susceptibility Testing.
A switch allows selection of triangular, square wave and sine wave shapes. The frequency range switch provides ten-to-one ranges from 15 Hz to 150 KHz in four steps. The calibra... View Details >>
|
|
|
|
|
|
| | Solar 7054-1 Spike Generator 600 Volts | For Conducted Transient Susceptibility Testing Up To 600 Volts Peak.
The peak amplitude of the Model 7054-1 Spike Generator is adjustable from 10 volts to over 600 volts into 5 ohms. The source impedance is less than 0.5 ohm. The transient shape a... View Details >>
|
|
|
|
| | Solar 7334-1 Loop Antenna | For RE01 and RE101 Magnetic Emissions Tests.
The Solar Type 7334-1 Loop Antenna has been designed as a substitute for the AT-205/URM-6 antenna and is a replacement for Eaton Model 94607-1. It uses 36 turns of wire on a 5.25" (13.3 cm) diamete... View Details >>
|
|
|
|
| | Solar 7399-2 Spike Generator 2500 Volts | For Conducted Transient Susceptibility Testing.
The Model 7399-2 Spike Generator is a “Big Bang” unit capable of providing high energy spikes with amplitudes adjustable up to 2500 volts; peak, into low impedance loads, as required by paragraph... View Details >>
|
|
|
|
| | Solar 7429-1 Loop Antenna | For RS01 Magnetic Field Tests.
The loop antenna used for generating radiated magnetic fields is fully described in Figure 1A of MIL-STD-461A. It consists of ten urns of number 16 A.W.G. wire on an insulated from 4.72" (12 cm) in diameter. The... View Details >>
|
|
|
|
| | Solar 8282-1 Transient Pulse Generator | For Conducted Transient Susceptibility Testing, 0.15 µS - 5.0 µS - 10.0 µS up to 600 volts (peak)
The Solar 8282-1 Transient Pulse Generator was designed for screen room use in making conducted spike susceptibility tests. It pro... View Details >>
|
|
|
|
|
|
|
|
| | Solar 8850-2 High Power Sweep Generator | For Conducted Audio Frequency Susceptibility Testing.
The Model 8850-2 Power Sweep Generator provides audio power in a manually tuned or sweeping mode for four frequency bands covering 30 Hz to 150 KHz. The sweep rate is compliant with the require... View Details >>
|
|
|
|
| | Solar 9130-1 Loop Antenna | For Receiving or Generating Magnetic Fields 10 kHz – 3 MHz
This antenna was designed as a replacement for Eaton 94608-1. It is similar to Stoddart 91117-2, 30-inch diameter loop, supplied with AN/URM-6B and NM-10A EMI receivers. In addition to o... View Details >>
|
|
|
|
|
|
| | Solar 9335-2 Multiple Impedance Coupling Device | Impedance Matching Injection Probe.
The unique winding arrangement of this impedance matching probe provides step-up or step-down ratios with respect to either: 1) the source impedance of the connected generator, when used for injection, or 2) the... View Details >>
|
|
|
|
| | Solar 9354-1 Transient Generator | For Susceptibility Tests MIL-STD461C/D/E and Other Specifications.
The Model 9354-1 & 9354-2 Transient Generators provide nine selectable waveforms, including six damped sinusoidal pulses (10 KHz,100 KHz, 1 MHz, 10 MHz, 30 MHz, and 100 MHz) a... View Details >>
|
|
|
|
| | Solar 9354-2 Transient Generator | For Susceptibility Tests MIL-STD461C/D/E and Other Specifications.
The Model 9354-1 & 9354-2 Transient Generators provide nine selectable waveforms, including six damped sinusoidal pulses (10 KHz,100 KHz, 1 MHz, 10 MHz, 30 MHz, and 100 MHz) a... View Details >>
|
|
|
|
| | Solar 9355-1 Pulse Generator | For MIL-STD461D/E CS115 Susceptibility Test.
The charged line potential of the Model 9355-1 is adjustable from less than 2 volts to greater than 2000 volts. The repetition rate is variable from less than 0.6 p.p.s. to greater than 150 p.p.s., or s... View Details >>
|
|
|
|
| | Solar Model 6254-5S RFI Transient Generator | For Conducted Transient Susceptibility Testing Up to 250 volts, peak
The Model 6254-5S RFI Transient Generator provides up to 250 volts peak amplitude. The output transient shape follows the curve given in Figure 19 of MIL-STD-462. Less than 1.0 m... View Details >>
|
|
|
|
|
